Writing a new Scan

I am still very much in the "discovery" phase with BullCharts - but I like everything about it and what it offers to "seekers of a better way"

I really need some assistance and guidance on how to develop a Scan based on the Klinger Oscillator.

My thinking is that to trade, the stock needs to be above a 89 EMA and then a buy occurs when the KO turns up from under the "0" line and crosses it, whilst the blue signal line crosses ( or has crossed) above the dotted trigger line. Not sure if I am calling these lines by their correct name - hence the line and the dotted line is used.

The above is based on trading the long side - reverse it for the short trading side.

Any assistance ( especially from BullCharts) would be most appreciated.

Edited by Rhubarb

Yep, Simon's reply looks pretty good. Though it doen't cover the zero line criteria you mentioned. So do the two he entered, then add:
 * Klinger Oscillator (13) Klinger Osc crosses above 0.

Also, for the second criteria he listed, you might consider changing "greater than" to "crossed above" depending on your needs.

If you find that these scans don't return any results, you can change the "condition" field to "Any time in the last 3 days" (or similar). This is especially important if you're looking for scanning on two different crossovers - otherwise if they don't happen on exactly the same day then it won't get matched.

Well, I was able to get the Scan operating, just fine....EXCEPT.....I overlooked an important requirement......I was looking to do this on a "Weekly" time basis - not daily. I have noted that in other scans which are produced for weekly charts - they make a note of this somewhere in the "works"

Peter, you may be able to direct me on this important modification.

This seems like a good time to show off another BullScan feature:

Say you're doing a weekly scan, and you run it on Thursday afternoon. You can choose to either scan at the close of the last week, or include the current week in progress as the last data point for the scan.

Eg: You might want something along the lines of "the volume for the week currently in progress must exceed the average volume by 100%", etc.

Tick the "Include Incomplete Period" checkbox below the period dropdown to access this feature.

A bar is  a generic word for a data point.  Referring to bar charts which is a common chart. So if weekly then the bar represents a week etc.  If we had only daily data then daily would be clear.  However with weekly etc we choose a generic word.